Panasonic VB-44210G - Page 192

Chapter 4. Key Telephone Features Section 700 - Operation
4-76 DBS Manual - Revised April 2000 DBS-2.3/9.2-700
7. Press the
AUTO
key.
8. Enter the Speed Dial number for the telephone number.
9. Repeat steps 7 and 8 for any additional Speed Dials to be chained.
10. Press the
HOLD
key.
11. Press the
ON/OFF
key.
The
ON/OFF
LED goes off.
To assign a DBS Feature Code to a One-Touch key:
1. Press the
ON/OFF
key.
• The phone issues intercom dial tone.
• The
ON/OFF
LED lights.
2. Press the
PROG
key.
3. Press the One-Touch key to be programmed.
4. Enter the feature code.
5. Press the
HOLD
key.
6. Press the
ON/OFF
key.
The
ON/OFF
LED goes off.
To assign an Outside Telephone Number to a One-Touch key:
1. Press the
ON/OFF
key.
• The phone issues intercom dial tone.
• The
ON/OFF
LED lights.
2. Press the
PROG
key.
3. Press the One-Touch key to be programmed.
4. Press
CONF
followed by the Pooled Trunk Access code (9, 81-86).
5. If a pause is required, press the
REDIAL
key.
This inserts a pause between the access code and the telephone number.