Section 700 - Operation Chapter 4. Key Telephone Features
DBS-2.3/9.2-700 DBS Manual - Revised April 2000 4-77
6. Enter the telephone number.
7. Press the
HOLD
key.
8. Press the
ON/OFF
key.
The
ON/OFF
LED goes off.
To check a programmed One-Touch key:
1. Press the
ON/OFF
key.
• The phone issues intercom dial tone.
• The
ON/OFF
LED lights.
2. Press the
CONF
key.
“C” appears in the display.
3. Press the One Touch key to be checked.
The programmed data appears on the display.
4. Press the
ON/OFF
key.
• The
ON/OFF
LED goes off.
• The date and time appears on the display.
Considerations
• If the pause following an access code is too short, press the
REDIAL
key
more than once.
• A One-Touch key can be programmed to automatically access a CO line
before dialing a personal speed dial number.
• Select an outside line group when you program a One-Touch key. A free
line is selected from that group when you dial out. (Group 9 can be
programmed to select LCR automatically.) The following table shows the
available outside line groups and their corresponding code numbers:
To Next Page
Loading...
