22
Ready to Watch TV?
1. Power on your KTC and other AV devices if necessary.
2. If the TV does not display promptly, press SOURCE to verify that TV is selected as your source (or a
different source according to the connection method you used in the Connection Suggestions
pages beginning on page 18.)
‘No Database’ Message
If the message “No Database’ appears when you are connected to digital cable, and TV is selected as
your source, the KTC may not be receiving a strong enough signal for the current channel to be
displayed. Perform the Initial Tuner Setup per the following instructions.
Initial Tuner Setup
The first time you power on the KTC after connecting a digital Coaxial RF cable, perform the following
initial setup and then your TV will be ready for viewing.
Note: Use the remote control to perform the initial tuner setup functions.
1. Press MENU to display the OSD menu.
2. Press VOL+ or VOL- to highlight the TV option.
3. Press CH- to highlight TUNER MODE and press VOL+ to select Cable or Air (antennae).
4. Press CH- to highlight AUTO SCAN.
If you have Cable selected, set Cable System to AUTO.
5. Press VOL+ to highlight START TO SCAN and then VOL+ again to start the scan.
To Next Page
Loading...
Need help?
General