15
3. Check the fuel filter.
Check whether the fuel filter is cracked or damaged, and check whether there is any dirt
in the fuel filter.
If yes, replace the fuel filter.
Attention:
Wipe up the spilled fuel.
Engine
Engine Oil Level
1. Remove the oil dipstick and check whether the oil level is between the upper and
lower marks of the oil dipstick.
1. Oil dipstick 2. High position mark 3. Low position mark
2. Drain the oil if it is above the high position mark, and add oil if it is below the low
position mark.
Attention:
Turn off the engine after running it and let it stand for several minutes. Check the oil level again with
the oil dipstick.
If the oil level is not within the specified range, add/drain oil to the specified value.
Replace Engine Oil
1. Remove the oil cap, oil drain bolt and bolt gasket; Drain the oil out.
2. Install a new bolt pad and install the oil drain bolt.
3. Add engine oil through the oil port.
Engine oil level: 2.0 L (The oil filter is not replaced)
2.2 L (oil filter is changed)
Oil type: API： SE, SF, SG, SH, SJ or SAE: 10W30, 10W40
4. Install oil filter cap.
5. Check oil level.
2
3
1
To Next Page
Loading...
Need help?
General
