3
Inspection before Delivery
In order to ensure the normal use of the products by customers, please carry out the following
inspections before delivery.
1. Check the fuel system.
Check that the fuel hose is securely connected and that the fuel tank is full of fuel.
Attention:
This is a four-stroke engine and premixed fuel cannot be used.
2. Check oil level.
○
1 Check engine oil level.
Pull out the oil dipstick and observe the oil level through the oil dipstick.
1. Oil dipstick 2. High position mark 3. Low position mark
Ensure that the oil level is between the high position mark and the low position mark;
Drain the oil when the oil level is higher than the high position mark, and add oil when it is lower
than the low position
mark.
○
2 Check gear oil level
Unscrew the oil level hole plug and observe whether there is oil overflow from the oil
level plug hole.
If yes, install the oil level hole plug and tighten it according to the specified torque. If
not, fill in oil.
1.Oil level hole plug
3. Check the steering system.
Check whether the steering is smooth;
4. Check shift and throttle operation.
Check whether the gear shift operation is smooth; Check whether the throttle grip
operates smoothly from the fully closed position to the fully open position.
5. Check the emergency stop switch assembly.
Check whether the engine stops when the emergency stop switch assembly is pressed or
the motor stop safety rope is pulled out.
6. Check the cooling water observation hole.
When the engine is running, check whether the cooling
water is flowing out of the cooling water observation hole.
1. Cooling water observation hole
1
1
2
3
To Next Page
Loading...
Need help?
General
