83
Continued
Disassembling and Check of Bracket
1. Remove the outer cover of the left and right absorbers, remove the left and right
absorbers and the retaining nuts of the double-hole absorbers.
2. Remove the water unit, oil pan and outlet manifold socket completely from the bracket
3. Remove the bracket clamp nut and clamp the bracket double-headed screw tube.
4. Disconnect the ground cable A and remove clamping bracket.
5. Remove support frame assembly A & B, remove the nylon bushing.
6. Remove fixed block limit circlip of the absorber, remove fixed block of the absorber.
Attention:
The absorber fixed block and the steering bracket assembly are splined and tightly connected. Please
be careful when disassembling and installing it.
Avoid accidental injuries; Do not disassemble unless necessary.
7. Pull out the steering bracket assembly and remove the liner, bushing and O-ring.
8. Check the rotary bracket and clamping bracket for cracks or damage. Replace it if
necessary.
9. Check the bushing and liner; If damaged or cracked, replace it.
10.
Check the support frame assembly A&B for deformation or damage. Replace it if necessary.
11.Check the rubber of the left and right absorbers for aging, cracking or degumming.
Replace it if necessary.
Disassembling and Check of Water Unit
1. Drain the oil.
2. Remove the mounting bolts on and under the water, and remove the water unit.
3. Remove outlet manifold socket, remove the oil pan.
4. Remove coarse filter assembly and coarse filter support from the outlet manifold seat.
5. Remove the exhaust pipe, oil drain screw, oil drain rubber sleeve and rubber conduit
A&B and the outlet manifold from the oil pan
To Next Page
Loading...
Need help?
General
