73
Disassembling and Check
1. Remove the rubber plug, corrugated rubber sleeve and throttle cable sheath.
Remove the ignition line assembly.
2. Remove the bolts securing the small cover plate of the bottom cover, remove the
small cover plate of the bottom cover, and remove the square rubber sealing strip.
Remove the opening stop plate and the rectangular rubber plug.
3. Remove the top cover locking handle screw, remove the top cover locking handle and
the top cover locking block.
4. Remove the top cover locking handle nylon sleeve A and top cover locking handle
nylon sleeve B.
5. Remove corrugated washer.
6. Remove the control cable connector A and remove the bolts of the throttle swing rod
seat.
7. Remove the throttle swing rod seat and remove the cotter pin on the throttle swing
rod assembly.
8. Remove the shift support, remove the shift linkage assembly, and remove the brake
rocker.
9. Check the top cover for cracks, damage or wear. Replace it if necessary.
10.Check the top cover locking handle and the top cover locking block for cracking or
damage. Replace it if necessary.
11.Check the corrugated washer and lock handle nylon sleeve A for cracks or damage.
Replace it if necessary.
12.Check the throttle swing rod seat and throttle swing for cracks or damage. Replace it
if necessary.
13.Check the shift linkage assembly for bending deformation or damage. Replace it if
necessary.
14.Check whether the shift cam plunger in the shift support slides flexibly. Replace it if
necessary.
15.For back-operation models, check whether the rocker of the micro switch is worn.
Check micro switch conductivity. Replace it if necessary.
To Next Page
Loading...
Need help?
General
