76
Continued
Disassembling and Check
1． Remove the handle bracket, remove the shift handle and remove the Steering
handle.
2． Remove the throttle cable assembly.
3． Remove the cotter pin and remove the resistance adjustment knob.
4． Remove the throttle grip.
5． Remove the throttle cover and throttle lever.
6． Remove the engine emergency stop switch.
7． Check the steel ball 12 on the shift handle assembly and the shift handle spring for
wear, fracture and sticking. Replace it if necessary.
8． Check the Steering handle for cracks or damage. Replace it if necessary.
9． Check the handle anti-wear ring and waveform washer for cracks or damage.
Replace it if necessary.
10．Check the cable in the throttle cable assembly for wear or fracture. Replace it if
necessary.
11．Check the teeth on the throttle lever gear assembly for wear or missing. If yes,
replace it.
12．Check the conductivity of the engine emergency stop switch; If it does not conform
to the regulations, replace it.
Remove locking plate: Conductive
Install locking plate: Not conductive
Press the switch button: Conductive
To Next Page
Loading...
Need help?
General
