7 Camware Features
pco.edge User Manual V1.03 © PCO AG, Germany
37
7.4 The Camera Menu
Camera Control
Use this command to open the camera control window (see 6.1).
Load Camera Settings
With this command you can reload camera settings which have been
previously saved. You can reload only a file which has been made with the
same camera configuration as it was found by the application at start-up.
Save Camera Settings
This command saves the actual camera settings of all existing cameras.
Create Hot Pixel List (for long exposure only)
This feature applies for cameras with exposure times longer than 5s and is
not applicable for the pco.edge camera.
Hotpixel Correction (for long exposure only)
Sophisticated hot pixel correction is already implemented in the pco.edge
camera.
Auto Exposure
Starts some exposures and tries to find an exposure time that captures
images with grey values between 1400 and 1500. It re-adjusts the lookup
tables in order to display the images with the new settings best. For low
light conditions only.
Close
Disconnects camera and switches Camware to Demo Mode. In case of
multiple cameras, all cameras must be closed in order for Camware to
switch to Demo Mode.
Rescan
Disconnect and reconnect camera.
Setup
Switch between Rolling Shutter, Global Shutter and Global Reset Mode.
Automatic restart of the camera.
To Next Page
Loading...
Need help?
General
