- 65 -
7 Inspection
1
5
2
6
3
7
9
4
8
10
1
Check if the uid level of sub-engine oil is in the vicinity of the upper limit
of the oil level gauge.
* Tighten the screw of oil level gauge rmly to check.
2
When the quantity of sub-engine oil is not enough, supply the designated
sub-engine oil from the oil inlet to the level not to excess the upper limit.
[ Refer to page 70 for the designated sub-engine oil.]
NOTE
●
When the error code " " is displayed during the refrigeration unit operation,
it is the time to change sub-engine oil. Please contact your nearest dealer and
request them to change the oil and the oil lter. Perform "cumulative time 1
reset" after changing them.
Inspection of sub-engine fuel quantity
Use the designated sub-engine fuel.
• Otherwise, it may cause damage of the sub-engine.
1
Always check the fuel quantity with the
fuel level gauge to avoid running short
of fuel during transportation.
2
If there is not enough fuel left in the
tank, refuel it.
[ Refer to page 70 for designated
fuel.]
NOTE
●
Stop the operation with the "Operation switch" when refueling.
Fuel gauge
To Next Page
Loading...