BRUSH CUTTER EXCELION 2 DH
53_153238-A
9. Using the special EXCELION 2 wrench (23) supplied
with your tool, unscrew the nut clockwise while hol-
ding the protective bowl.
10. Remove the protective bowl.
11. Check that the anti-vegetation protection washer
(25) is present on the angle gear (11).
12. Place the following parts in turn on the angle gear:
• the chisel-saw blade (ref. 111700),
Note
Pay attention to the mounting direction. The
direction of the arrow engraved on the blade
must match that of the arrow on the housing.
• the protective bowl.
13. Using the special EXCELION 2 wrench (23) supplied
with your tool, tighten the nut anti-clockwise while
holding the protective bowl.
Tightening torque: 35 N m.
Note
After fitting your cutting head on your tool, it is ne-
cessary to select it in the HMI to operate the tool.
Refer to Section 5.5.2, « Activation of the cutting
head via the HMI menu ».
34
To Next Page
Loading...
