Installing Drivers for 6000 Boards
RS232 USB
Suse 10.1/10.2/10.3/11/11.1 ● ●
Suse 10.0 ●
Linux For GPM ● ●
QNX 6.4 ●
QNX 6.3 ●
3.3.1. Install PenMount Linux X Window RS-232 Driver and USB
Driver
See the readme file included in the driver folder.
3.3.2. Calibration Utilities
See the readme file included in the driver folder.
3.4. Install PenMount WinCE Driver
Before installing PenMount WinCE Driver, you must have WinCE system installed and
running on your device. You must also have PenMount USB control boards either 6200x,
6202B, 6300 or 6500 installed.
NOTE: Make sure you can move the WinCE cursor with a serial mouse attached to the
target COM port (e.g. COM2) before connecting the 6000 control board by
RS-232 port.
3.4.1. Install PenMount WinCE Driver
Please see the readme file included in the driver folder.
To Next Page
Loading...
