51
Chapter 5. PenMount Gesture AP for Windows
2000/XP/VISTA/7
This chapter will guide you to the PenMount Gesture AP that is applicable in Windows
2000/XP/Vista/7.
5.1. Invoke PenMount Gesture AP
1. Make sure you have installed PenMount touchscreen control boards (whether 6000
or 9000 series).
2. Make sure you have installed PenMount Universal Driver V2.1.0.263 or later versions
to your system.
3. To run PenMount Gesture AP, either:
In the notification, right-click on the PenMount icon and select Gesture Enable from
the menu. A PenMount Gesture AP icon will show up in the notification area. See the
illustration below. PenMount Gesture AP is running.
or
In PenMount Control Panel, select Tools tab and press Gesture Enable button.
PenMount Gesture AP icon shows up in the notification area. PenMount Gesture
AP is running.
PenMount Gesture AP
Enabled Disabled
To Next Page
Loading...
