Driver Software Functions
45
or
Multiple Monitors function shown above extends the screen into 2 or more
monitors.
Multiple Devices function displays the same image on two or more monitors.
4.4.2. Requirements
To use Multiple Devices with 6000 Control Boards, you need to do the
following:
To connect with RS-232 ports:
1. Configure your computer hardware. See Chapter 2. Install PenMount
6000 Control Boards.
2. Attach each 6000 board to a different computer’s serial port.
3. Install the PenMount Windows Universal Driver (for
2000/XP/2003/VISTA/7) in each computer – see Chapter 3. Install
Drivers for 6000 Boards for details.
4. Use driver’s Calibration function to calibrate each computer’s
touchscreen. You must calibrate each touchscreen before configuration
is complete.
To connect with USB ports:
To Next Page
Loading...
