Pentair Biffi ICON 2000 - Entering View Mode; Entering Set-Up Mode; Exiting View and Set-Up Modes

23
BIFFI ICON 2000
InstructIon and operatIng manual
6.3 ENTERING THE VIEW MODE
The existing actuator configuration should
be checked before commissioning. The
parameters are configured in factory
according to a standard setting, or to customer
requirements. In view mode, no password is
requested, but no change of parameters can
be made.
•Ensuretheelectricalmainpowerisapplied.
•Movethe3-positionselectortoOFFandthen
simultaneously press OPEN/YES and STOP.
•Thedisplayshowsthepresentlanguage.
Press YES to confirm or NO to scroll the list
of available languages. Press YES to select a
new language. Press YES to confirm.
•PressNOtoscrollthelistofavailablemenus
(actuator set-up, nameplate, valve data,
maintenance) and then press YES to select
the desired menu.
•PressNOtoscrollthelistofavailable
routines and press YES to select the routine
where the parameter to be changed is
located.
•PressNOtoscrollthelistofparametersand
press YES to view the value.
6.4 ENTERING THE SET-UP MODE
To change the existing settings or to set the
stroke limits it is necessary to enter the correct
password.
•Ensuretheelectricalmainpower(orthe
external auxiliary supply) is applied.
•Movethe3-positionselectortoOFFandthen
simultaneously press OPEN/YES and STOP.
•Thedisplayshowsthepresentlanguage.
Press YES to confirm or NO to scroll the list
of available languages. Press YES to select.
Press YES to confirm the chosen language.
•PressNOwhenthemessageis
“VIEWMODEOK?”.PressYEStoanswer
prompt“ENTERPASSWORDOK?”.
•Enterpassword.Enteronedigitatatime.
Press YES if digit is correct, press NO to
scroll the list of available characters and
then press YES when the character is
correct. Enter 4 digits. After entering the
last digit, the microprocessor checks the
password. If it is correct the messages
“PASSWORD CORRECT” and then
“SET-UPMODEOK?”appear.PressYES.
•PressNOtoscrollthelistofavailablemenus
(actuator set-up, valve data, maintenance)
and press YES to select the desired menu.
•PressNOtoscrollthelistofavailable
routines and press YES to select the routine
where the parameter to be changed is
located.
•PressYESandNOtoanswertheprompton
the display and change the parameter.
•Ifthepasswordiswrongthemessage
“PASSWORD WRONG” appears and set-up
mode will not available.
6.5 EXIT FROM VIEW AND SET-UP MODE
The following conditions cause the exit from
view and set-up mode:
•Movethe3-positionselectortoLOCALor
REMOTE.
•AnswerYESwhenthedisplayasks
“EXITOK?”.
•PressYESandNOsimultaneously.
•Automaticexitafter90minuteswithoutany
parameter change or view.
•Removetheelectricalpowerfromtheunit.
All settings are automatically saved to a
non-volatile memory and retained also if the
electrical power is removed from the actuator.
All ICON 2000 actuators are configured before
shipping with a standard default setting unless
alternatives were requested on order. In case
of difficulty during commissioning, the default
setting can be re-instated by the appropriate
function in the routine ”miscellaneous” of the
actuator set-up menu. The actuator returns to
its original configuration and commissioning
can be resumed.