BIFFI ICON 2000 / ICON 2000 AD
Addendum C to InstruCtIon And operAtIng mAnuAl
c Ex d IIC T4 Gb / c Ex tb IIIC T135°C Db IP66/68
c Ex d ia IIC T4 Gb / c Ex tb IIIC T135°C Db IP66/68
On the compartment containing the intrinsic safety circuit, the marking: Ex ia IIC T4 Ga
INDEX
1 Safety instructions ................................. 1
2 Instructions for right installation ......... 1
2.1 Marking .................................................... 1
3 Applicable directives, general
standards and norms ............................. 2
4 Terms and conditions ............................. 2
5 Manufacturer’s liability ......................... 2
6 Storage and pre-installation ................. 2
6.1 Storage procedure ................................... 2
6.2 Checks to be performed before
installation ................................................ 2
7 Installation .............................................. 3
7.1 Working condition .................................... 3
7.1.1 Models and temperature......................... 3
7.2 Identification of entries ............................ 3
7.3 Electrical connections ............................. 3
7.4 Cable connection ..................................... 3
7.5 Installation in ambient with
explosive dusts ......................................... 3
8 Maintenance ............................................ 4
8.1 Periodic inspections ................................ 4
8.2 Dismantling and reassembling .............. 4
8.3 Repairs ..................................................... 4
WARNING
It is assumed that the installation, setting,
commissioning, maintenance and repair works
are carried out by qualified personnel and
checked by responsible specialists.
1. SAFETY INSTRUCTIONS
1.1 GENERAL
This Addendum C to ICON 2000 main IOM
VCIOM-01232 prescribes the safety instructions
applicable to all the electric actuators
ICON 2000-010 and ICON 2000-020, certified
according to the EN 60079-0 and IEC Standards
60079-1, 60079-11, 60079-31 for protection
mode Ex d or Ex d ia for gas group IIC and
Ex tb IIIC for dust suitable to be installed in an
ambient temperature range from -60°C (-76°F)
to +85°C (+185°F).
ICON 2000 is designed in accordance with the
applicable international rules and specifications
but in any case the following regulation must
be observed:
- The general installation and safety
regulations.
- The proper use of personal protective devices
(glasses, clothing, gloves).
- The proper use of tools, lifting and transport
equipment.
www.pentair.com/valves © 2012 Pentair plc. All rights reserved. VCIOM-03022-EN 15/03
2. INSTRUCTIONS FOR RIGHT
INSTALLATION
WARNING
Before the installation it is mandatory to check if
the nameplate specifies the appropriate degree
of protection and ambient temperature limits as
requested by the rules applicable to the plant/
location where ICON 2000 are installed.
Installation in ambient with the presence of
explosive atmosphere not covered by the specified
grade of protection, or which could reach
temperature higher than the maximum specified
on the label, will invalidate the safety and the
warranty.
IMPORTANT
Check if the label, as the following example,
is fixed on the unit and completed with all the
appropriate information.
2.1 MARKING
Template of the label for ICON 2000 / ICON 2000 AD
To Next Page
Loading...
