Pentair Biffi ICON 2000 - Page 39

39
BIFFI ICON 2000
InstructIon and operatIng manual
Last maintenance date
•PressYESifthedateiscorrect,pressNOto
change it.
•Enterday,month,andyear.PressNOto
scroll the list of available values, press YES
to select.
•PressYESifthedateiscorrect.
Next maintenance date
•PressYESifthedateiscorrect,pressNOto
change it.
•Enterday,month,andyear.PressNOto
scroll the list of available values, press YES
to select.
•PressYESifthedateiscorrect.
Configuration procedure
•MovethelocalselectortoOFFandthen
simultaneously press OPEN and STOP.
Select the language and enter the password
according to the instructions (see “Entering
the set-up mode”). When the message
displayedis“SET-UPMODEOK?”pressYES.
Press NO to scroll the list of available menus
and then YES to select the maintenance
menu.
•PressNOtoscrollthelistofavailable
routines and press YES to select maintenance
date.
•PressYEStosetthelastmaintenancedate.
Press NO to skip to “next maintenance date”.
9.3.6 Set maintenance date
The maintenance date routine allows the
following operations:
- to set the last maintenance date
- to set the next maintenance date
- to set the start-up date
Start-up date
•PressYESifthedateiscorrect,pressNOto
change it.
•Enterday,month,andyear.PressNOto
scroll the list of available values, press YES
to select.
•PressYESifthedateiscorrect.
9.3.7 Set data logger
The “data logger” routine allows to set the
data logger parameters (see VIEW mode,
Maintenance, Data logger, paragraph 10.4.6).
To start the data logger the following data
should be set:
Logger mode recorder, event, off
Sampling time from 1 to 3600 secs (the sampling time is only used in recorder mode)
Memory mode stop when memory is full, continuous (stop after overwriting the memory 5000 times (event)
and 10000 times (recorder/T-recorder)
Start date date when the logger starts
Start time time when the logger starts
Configuration procedure
•MovethelocalselectortoOFFandthen
simultaneously press OPEN and STOP. Select
the language and then enter the password
according to the instructions (see “Entering
the set-up mode”). When the message
displayedis“SET-UPMODEOK?”pressYES.
Press NO to scroll the list of available menus
and then press YES to select maintenance
menu.
•PressNOtoscrollthelistofavailable
routines and then press YES to select
“data logger”.
•PressYESifthemodeiscorrect.PressNO
to scroll the list of modes and press YES to
select the desired value .
•PressYESifthesamplingtimeiscorrect.
Press NO to scroll the list of times and press
YES to select the desired value.
•PressYESifthememorymodeiscorrect
(stop when full or continuous). Press NO to
change and press YES to select.
•PressYESifthestarttimeiscorrect.Press
NO to scroll the list and press YES to select
the desired sampling times (hour, min, sec).
•PressYESifthestartdateiscorrect.Press
NO to scroll the list and press YES to select
the desired sampling times (day, month,
year).
•PressYEStoconfirmtheabovesettings.