Pentax ist DL - Page 5

76570EM 4
(3) FRONT HOUSING BLOCK.......................................................................................
29
(4) 0-Q200 (FLASH PC BOARD, A15 AND A15)............................................................
29
(5) A6 (LEFT SHOULDER PLATE)................................................................................
30
(6) T901 (LOWER FLEX BOARD)..................................................................................
30
(7) 0-A3 (BOTTOM PLATE ASSY)..................................................................................
31
(8) T200 (UPPER FLEX BLOCK)...................................................................................
31
(9) LCD BLOCK...............................................................................................................
32
(10) [CONFIRM] CCD BASE PLATE SUPPORT PILLAR...............................................
33
(11) [ADJUST] SHUTTER SPEED (1/4000).......................................................................
34
11-1. PREPARATION 1....................................................................................................
34
11-2. PREPARATION 2 (BATTERY CONSUMPTION CURRENT AND
FUNCTION CHECK)...........................................................................................
34
11-3. ADJUSTMENT........................................................................................................
35
11-4. REMOVE TEMPORARY INSTALLED PARTS.....................................................
35
(12) 0-T600 (CCD BLOCK)..............................................................................................
35
(13) 0-T100 (MAIN PC BOARD)......................................................................................
36
(14) [CONFIRM] FUNCTION CHECK 1...........................................................................
37
14-1. PREPARATION......................................................................................................
37
14-2. POWER SUPPLY CHECK.....................................................................................
37
14-3. WRITING FIRMWARE..........................................................................................
38
14-4. SETTING TEST MODE.........................................................................................
38
14-5. SHUTTER RELEASE AND EXPOSURE..............................................................
39
14-6. AF FUNCTION.......................................................................................................
39
14-7.CANCELLATION OF TEST MODE AND REMOVING TEMPORARY
INSTALLED PARTS...............................................................................................
39
(15) A201 (BACK COVER)...............................................................................................
39
(16) A150 (FRONT COVER)............................................................................................
41
(17) A161 (FORWARD RIGHT COVER).........................................................................
41
(18) [ADJUST] POSITIONING 0-J100..............................................................................
42
(19) 0-A301 (TOP COVER)..............................................................................................
43
(20) [CONFIRM] FUNCTION CHECK 2...........................................................................
45
20-1. PREPARATION......................................................................................................
45
20-2. BATTERY CONSUMPTION CURRENT CHECK................................................
45
20-3. AF AND SI FUNCTION CHECK...........................................................................
45
20-4. EXPOSURE MODE AND SHUTTER RELEASE.................................................
45
20-5. SWITCH TEST (EACH SW AND CONNTACT OF DIAL)...................................
46
20-6. SHOOTING AND PLAYBACK FUNCTION.........................................................
46
20-7. FLASH FUNCTION CHECK.................................................................................
47
20-8. [ADJUST] FLASH STORE POSITION.....................................................................
47
20-9. APERTURE CONTROL CHECK AND SURFACE OF CCD CHECK..................
47
20-10. SD CARD COVER SWITCH CHECK..................................................................
48
(21) [ADJUST] ADJUSTMENT WITH PROGRAMMED SOFTWARE
(SLR OPERATION)....................................................................................................
48