peplink 20 User Manual

USER MANUAL
Peplink Balance Series
17.4.4 Email Settings
Once you have selected for Guest Account mode as the Captive portal modem in section 17.4.1, the
Email Settings tab will be available. Under this page, email server and templates can be set. Automatic
emails will be sent with the specified information.
Email Server / Template Settings
Sender’s Name
This is to specify the sender’s name of the email.
Sender’s Email
Address
This is to specify the sender’s email address of the email.
SMTP Server
This is to specify the SMTP server which will be used to send email. If the Server
requires authentication, check the box Require authentication.
SMTP User Name /
Password
This setting specifies the SMTP username and password while sending email. These
options are shown only if Require authentication
check box is checked in SMTP Server
setting.
http://www.peplink.com -133 / 207 - Copyright © 2013 Peplink

peplink 20 Specifications

General

Load Balancing	Yes
VPN Support	Yes
Power over Ethernet (PoE)	No
LAN Ports	4
LAN Interface	4x GE
Wi-Fi Standard	802.11ac
PepVPN/SpeedFusion Throughput (AES 256	200 Mbps
Power Input	12V DC