USER MANUAL
Peplink Balance Series
In addition, a single port, or a range of ports, can be specified for the Source IP &
Portsetting.
Destination IP &
Port
This specifies the destination IP address(es) and port number(s) to be matched for a
firewall rule.
A single address, or a network, can be specified as the Source IP & Port setting, as
indicated with the following screenshots:
In addition, a single port, or a range of ports, can be specified for the Source IP &
Portsetting.
Action
This setting specifies the action to be taken by Peplink Balance upon encountering traffic
that matches the both of the following:
• Source IP & Port
• Destination IP & Port
With the value of Allow for the Action setting, the matching traffic passes through Peplink
Balance (to be routed to the destination).
If the value of the Action setting is set to Deny, the matching traffic does not pass through
Peplink Balance (and is discarded).
Event Logging
This setting specifies whether or not to log matched firewall events.
The logged messages are shown on the page Status > Event Log.
A sample message is as follows:
Aug 13 23:47:44 Denied CONN=Ethernet WAN SRC=20.3.2.1
DST=192.168.1.20 LEN=48 PROTO=TCP SPT=2260 DPT=80
• CONN: The connection where the log entry refers to
• SRC: Source IP address
• DST: Destination IP address
• LEN: Packet length
• PROTO: Protocol
• SPT: Source port
• DPT: Destination port
Upon clicking Saveafter entering required information, the following screen appears.
http://www.peplink.com -145 / 207 - Copyright © 2013 Peplink
To Next Page
Loading...
Need help?
General
