USER MANUAL
Peplink Balance Series
Inbound / Outbound Firewall Settings
Rule Name
This setting specifies a name for the firewall rule.
Enable
This setting specifies whether the firewall rule should take effect.
When Yes is selected, the firewall rule takes effect. If the traffic matches the specified
Protocol/IP/Port, actions will be taken by Peplink Balance based on the other parameters of
the rule.
When No is selected, the firewall rule does not take effect. Peplink Balance will disregard
the other parameters of the rule.
WAN Connection
This setting is applicable to Inbound Firewall Rules only.
This setting specifies the WAN connection(s) on which the rule applies:
1. Any
2. WAN1
3. WAN2
4. WAN3 (applicable only to Peplink Balance 30, 310, 305, 380, 580, 710, 1350 and
2500)
5. WAN4 to WAN5 (applicable only to Peplink Balance 580, 710, 1350 and 2500)
6. WAN6 to WAN7(applicable only to Peplink Balance 710, 1350and 2500)
7. WAN8 to WAN12 (applicable only to Peplink Balance 1350, 2500)
8. WAN 13 (applicable only to Peplink Balance 1350)
9. Mobile Internet (applicable only to Peplink Balance 20, 30, 305,380, 580, 710,
1350and 2500)
A value of Any, WAN1, WAN2, … and Mobile Internetspecifies that the rule applies to all
WAN connections, WAN1, WAN2, … and Mobile Internet, respectively.
Protocol
This setting specifies the protocol to be matched.
Via a drop-down menu, the following protocols can be specified:
• TCP
• UDP
• ICMP
• IP
Alternatively, the Protocol Selection Tool drop-down menu can be used to automatically
fill in the Protocol and Port number of common Internet services (e.g. HTTP, HTTPS, etc.)
After selecting an item from the Protocol Selection Tool drop-down menu, the Protocol
and Port number remains manually modifiable.
Source IP & Port
This specifies the source IP address(es) and port number(s) to be matched for a firewall
rule.
A single address, or a network, can be specified as the Source IP & Port setting, as
indicated with the following screenshots:
http://www.peplink.com -144 / 207 - Copyright © 2013 Peplink
To Next Page
Loading...
Need help?
General
