Chapter 3 TPD1317e
Page 12
In order to achieve sufcient height above the waterline it may be necessary to use the system shown in
Figure 2. This also enables the two elbows to be rotated relative to each other to allow the exhaust hose to
run towards the side of the boat. The arrangement shown raises the exhaust height above the turbocharger
outlet by about 230mm (9 inches) - greater heights can be achieved if necessary by using the arrangement
described in Section 3.3.
Elbow with facility for
water injection
Possible
rotation
Dry elbow
Insulating blanket
Figure 2 - High rise exhaust elbow.
To Next Page
Loading...
