TPD1317e Chapter 11
Page 73
11.3 M135, and M130C Engines
Model M135 Model M130C
Basic Technical Data
Rated power 130 PS (96 kW)
Rated engine speed 2600 rev/min
Number of cylinders 6
Cylinder arrangement In-line
Cycle 4 stroke
lnduction system Naturally aspirated
Bore 100 mm (3.937”)
Stroke 127 mm (5.00”)
Compression ratio 16.5:1
Cubic capacity 6.00 litres (365 in
3
)
Valves per cylinder 2
Direction of rotation Anti-clockwise viewed on ywheel
Firing order 1, 5, 3, 6, 2, 4
Total weight (wet) 595 kg (1312 lb) engine only including starter and alternator.
Cooling System The coolant shown below is mandatory for use in all climates to
ensure that adequate levels of corrosion inhibitor are present.
It will give frost protection to -37
o
C.
Coolant 50% inhibited ethylene glycol or
50% inhibited propylene glycol with 50% fresh clean water
Fresh water ow 213 litre/min (47 gall/min) at 2600 rev/min
Coolant pump speed and
method of drive. 1:1 Gear driven
System capacity 25.3 litres (5.6 gallons)
Pressure cap setting 48 kPa (7 psi)
Protection switch setting 96
o
C
Sea water pump type Jabsco gear driven model 25.4 mm (1”) full cam.
Sea water suggested inlet
hose diameter. 32 mm (1.25”)
Sea cock Full ow 25.4mm (1.00”)
Strainer A raw water strainer must be included in the suction side of the circuit.
To Next Page
Loading...
