TPD1317e Chapter 7
Page 45
7.4 Interconnecting Cable
Interconnecting cables (Figure 10) are used to join the engine loom to the instrument panel(s). Cables are
made in 4, 6, 8, 10 and 12m lengths and all cables have a male plug (1) at one end and a female (2) at the
other. Cables may be plugged together to give up to 12m length, but in general if a longer cable is required it
should be ordered as a special item, to be made in one piece.
A ‘Y’ harness (Figure 11) is available, with a male plug at (1) and two female plugs (2). If necessary, more than
one ‘Y’ harness may be used, to connect several instrument panels together, in any of the combinations shown
on Figure 15.
Details of the plugs and sockets, and the wiring of the ‘Y’ harness are shown on Figure 11.
Figure 10 - Interconnecting cable
Figure 11 - ‘Y’ harness
To Next Page
Loading...
