SERVICE OPERATIONS
20
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
SERVICE OPERATIONS
Changing the engine oil
The engine must be drained when it is
warm to allow the oil to run easier.
Wear gloves in order not to get burnt.
- Place the vehicle on its central stand on flat
ground.
- Remove the engine's oil filler cap (1).
Remove the drainage cap and its
seal (2) and allow the oil to drip into a
recipient.
Replace the copper seal every time you
change oil.
- Remove the strainer cap (3) and clean the
strainer (4).
Every time oil is changed, the filter (4)
must be cleaned and the O-ring
changed (5).
- Put back the drainage cap and strainer cap,
fitted with a new seal.
Tightening torques:
• Filler cap: 20 Nm.
• Screen: 15 Nm.
- Pour the required quantity of oil
corresponding to the manufacturer's
standards into the filler hole.
Quantity: 0.65 l.
1
XXXXXX-X
*
XXXXXXXX
*
2
To Next Page
Loading...
Need help?
General