Pfaff 1491E1 - Knife Position with Regard to Needle Plate

Adjustment
13 - 29
Fig. 13 - 25
7
3
6
5
4
1
8
2
2
2
13.06.02 Knife position with regard to needle plate
Requirement
With the edge trimmer swung in, the knife 2 must be parallel to the needle plate insert.
● Turn the machine off and swing in the edge trimmer.
● Loosen screw 1 and push the knife 2 back a little.
● Turn milled screw 3 in such a way that its top edge is flush with the top edge of the
cylindrical guide 4.
● Loosen screw 5, position guide 6 in the middle of guide 7 and tighten screw 5 lightly.
● Turn the knife carrier 8 in accordance with the requirement and tighten screw 5.
Screw 1 remains loosened for the following adjustments.