Adjustment
13 - 1
13 Adjustment
13.01 Notes on adjusting
All adjustments in these adjustment instructions are based on a completely installed
machine and must only be carried out by appropriately trained specialists. Covers on the
machine which have to be removed and replaced for checks and adjustment work are not
mentioned here. The screws and nuts in brackets () are attachments of machine parts which
are to be loosened before making the adjustment and tightened again when the adjustment
is complete.
13.02 Tools, gauges and other accessories for adjusting
● 1 set of screwdrivers with blade widths from 2 to 10 mm
● 1 set of wrenches with jaw widths from 7 to 13 mm
● 1 set of Allan keys from 1.5 to 6 mm
● 1 adjustable clamp, ( Part No. 08-880 137-00 )
● 1 metal rule, (Part No. 08-880 218-00)
● 1 adjustment pin ( needle position in sewing direction, Part no. 61-111 641-46 )
● 1 adjustment gauge, ( Part No. 08-880 136-01 )
● 1 adjustment gauge, ( Part No. 61-111 643-33 )
● 1 adjustment pin for needle bar rinse ( Part No. 61-111 641-39 )
● Needles, system 134
● Sewing thread and test material
13.03 Abbreviations
TDC = top dead center
BDC = bottom dead center
To Next Page
Loading...
