Pfaff 1491E1 - Pedal; Knee Switch; Knee Lever

Controls
7 - 2
7.03 Pedal
0 = Machine stop
1 = Sew
2 = Raise roller presser
3 = Trim thread and raise roller
presser
Other pedal functions can
also be programmed
(see chapter 10 Sewing)
Fig. 7 - 03
0
1
2
3
7.04 Knee switch / knee lever
2
Fig. 7 - 05Fig. 7 - 04
● By activating the knee switch 1 the end of the seam section can
be signalized during programmed sewing.
● The roller presser is raised by pressing the knee lever 2 in the direction of the arrow .
The function of the knee switch 1 must be switched on using the
control panel (see chapter 11 Programming).
1