Pfaff 1491E1 - Limiting the Needle Bar Frame (1491 E1)

Adjustment
13 - 8
13.04.06 Limiting the needle bar frame ( 1491E1 )
Requirement
With the stitch length set at "5", screw 4 must be the same distance from the inner edge
of the mounting hole when the needle is at both the front and rear points of reversal.
1
4
Fig. 13 - 03
=
=
4
2
3
● Turn the machine on and set the stitch length at "5".
● Check the requirement by turning the single start bartack on and back off again.
● For the adjustment, move latch 1 (screw 2 and nut 3) in accordance with the
requirement.