Controls
7 - 4
Button type
● With these keys the type of button required (two-, four- or three-hole button) can be
selected.
● When entering the code number these keys correspond to the figures 1, 2 or 3.
Program group A
● When entering the code number this key corresponds to the figure 4.
Program group B
● When entering the code number this key corresponds to the figure 5.
Sewing mode/parameter input
● With this key it is possible to switch from the sewing mode (LED on) and the parameter
input mode (LED off).
Entering the seam pattern
● If this key is pressed the seam pattern function is switched on or off, see Chapter 11.01
or 11.02 Entering the seam pattern.
● When entering the code number this key corresponds to the figure 7.
Piece counter
● If this key is pressed the piece counter is reset (LED has no function).
● When entering the code number this key corresponds to the figure 8.
F1 key
● This key is reserved for special functions.
● When entering the code number this key corresponds to the figure 9.
Enter
● This key is used to confirm inputs and acknowledge error corrections.
To Next Page
Loading...
