11 - 10
Input
200
201 1
204 1
204 2
11.03 Parameter input
11.03.01 Selecting and changing parameters
● Switch on the machine.
● Switch to parameter input (LED on the key is off).
● Select the function group, e.g. "200" with the corresponding plus/minus key.
● Confirm with Enter.
● Enter the code, see Chapter 11.03.02 Entering/changing the access code.
● Select parameter "204" (seam pattern size) with the corresponding plus/minus key.
● Select the parameter value with the corresponding plus/minus key.
● By pressing the sewing mode/parameter input key the values are stored, and the
machine is then in the sewing mode.
By pressing the basic position key the parameter input is interrupted, the old
values are kept and the machine changes to the basic position of the parameter
input mode.
To Next Page
Loading...
