Adjustment
13 - 27
Fig. 13 - 25
1
2
3
4
5
7
7
5
6
13.27 Basic setting of the end knotting equipment
Requirement
Retaining finger 5 should be parallel to loop spreader 7.
● Dismount cloth plate and needle plate.
● First of all remove screw 1 (nut 2), until pin 3 is touching the wall of hole 4.
● Then turn screw 1 round once and fix with nut 2.
● Align retaining finger 5 (screws 6) in accordance with the requirement.
To Next Page
Loading...
