Pfaff 3307-1 SERIES - Error Messages on the Display

Adjustment
13 - 45
800 815 Right of access key three-hole button 0 - 1
■
0
816 Right of access key program group A 0 - 1
■
0
817 Right of access key program group B 0 - 1
■
0
818 Right of access programming key 0 - 1
■
0
819 Enter access code
(status on delivery: 3307) 0 - 9999 3307
13.40 Error messages on the display
Error 1 System error
Error 2 Sewing motor
30: Time out + motor defect
20: Time out + motor defect
10: Speed + motor defect
0B: StopX + motor defect
0A: Reset stitch counter + motor defect
9: Write parameter + motor defect
5: Position tdc shortest path + motor defect
3: Position tdc backwards + motor defect
2: Position tdc forwards + motor defect
Error 3 Input feed plate in (E6 - X5:14)
Error 4 Missed stitch with needle penetration number or end knotting
error with needle penetration number
Error 5 Clamp entrance at bottom (E4 – X5:4) switch clamp locked as main
drive not in t.d.c. position
Error 6 Time monitoring when going through the sewing program
Error 7 1 Delay X not finished
2 Delay Y not finished
3 Delay X and Y not finished
4 Ramp X not finished
5 Ramp Y not finished
Group Parameter Description Setting Set value
range
■
0 = free access, 1 = access only with code input