Adjustment
13 - 46
Error 8 Stitch length
Error 9 Seam outside area
Error 10 1 Error when moving the machine into home position, outputs
not finished
2 Raise clamp
3 Insert position not reached
6 Foot pedal operated
7 X-centre not reached
8 still at X-centre
9 Y-centre not reached
10 still at Y-centre
11 time control home test
12 Absolute position –0.3 not reached home test
13 Absolute position +0.6 not reached home test
14: Main drive unit has not reached t.d.c. position
Error 11 Stepping motor step frequency too high
Error 12 Error in sewing program
Error 13 Set position of stepping motor outside sewing area
Error 14 Time control outputs
3: Thread clamp
6: Thread wiper
15: Programmable output 1
Error 15 Input signal not received
Error 16 Delay time with running sewing drive not permitted
Error 17 Cutting without sewing
Error 18 Incorrect command in data set
Error 19 Incorrect program number
Error 20 not assigned
Error 21 Power supply unit overload (24 V)
Error 22 Mains voltage
Error 23 Power supply unit 24 V too strong / too weak
Error 24 No stepping motor movement prepared (needle in material)
Error 25 Stepping motor not started yet (needle in material)
To Next Page
Loading...
Need help?
General
