Contents
Contents .................................................................................Chapter – Page
13.
14 Readjusting the needle height..................................................................................... 13 -14
13.15 Adjusting the loop spreader ........................................................................................ 13 -15
13.16 Position of the loop spreader to the needle................................................................. 13 -16
13.17 Adjusting the thread trimmer ...................................................................................... 13 -17
13.18 Manual cutting test ..................................................................................................... 13 -18
13.19 Adjusting the thread catcher ....................................................................................... 13 -19
13.20 Adjusting the thread loop support ............................................................................... 13 -20
13.21 Basic position of the button clamp drive ..................................................................... 13 -21
13.22 Aligning the button clamp (only on subclass -1/..) ....................................................... 13 -22
13.23 Aligning the work clamp (only on subclass -4/..).......................................................... 13 -23
13.24 Aligning the button holder and button support (only on sub-class -5/..) ....................... 13 -24
13.25 Adjusting the clamp pressure (only on subclass -1/..).................................................. 13 -25
13.26 Aligning the cloth plate (only on subclass -1/.. and -4/.. ) ............................................. 13 -26
13.27 Basic setting of the end knotting equipment .............................................................. 13 -27
13.28 Adjusting the retaining finger of the end knotting equipment ..................................... 13 -28
13.29 Adjusting the lifting lever of the end knotting equipment............................................ 13 -29
13.30 Adjusting the reed switch ........................................................................................... 13 -30
13.31 Setting the angle for the end knotting (only on subclasses -1/.. and -4/..).................... 13 -31
13.32 Adjusting the moment tension.................................................................................... 13 -32
13.33 Adjusting the thread puller .......................................................................................... 13 -33
13.34 Adjusting the thread clamp ......................................................................................... 13 -34
13.35 Adjusting the thread regulator..................................................................................... 13 -35
13.36 Adjusting the button holding cylinder (only on subclass -5/..) ...................................... 13 -36
13.37 Adjusting the thread wiper (only on subclass -5/..) ...................................................... 13 -37
13.38 Cold start ....................................................................................................................13-38
13.39 Parameter settings...................................................................................................... 13 -39
13.39.01 Selecting and altering parameters............................................................................... 13 -39
13.39.02 Parameter list.............................................................................................................. 13-40
13.40 Error messages on the display.................................................................................... 13 -45
13.41 Motor errors................................................................................................................ 13-47
13.42 Data backup and protection with PC-program SAM.................................................... 13 -48
13.43 Internet update of the machine software.................................................................... 13 -49
14 Wearing parts ............................................................................................................ 14 - 1
15 Circuit diagrams ........................................................................................................ 15 - 1
To Next Page
Loading...
