Adjustment
13.04.19 Roller presser pressure
Requirements
1. The material must be fed reliably.
2. There must not be any pressure marks on the material.
Fig. 13 - 18
● Adjust the roller presser pressure with screw 1 in accordance with the requirements.
Screw 1 is underneath a cover.
When the roller presser pressure is low, the lowering speed of the roller
presser can be increased by turning on the function ROLLER PRESSER
DE-ENERGIZER. See chapter 11.08 Summary of the functions in the input
menu.
1
-
+
13 - 22
To Next Page
Loading...
