Pfaff 421E1 - Example of Teach in Programming

Programming
11 - 32
● Program the fourth (last) seam section:
This seam section should have
- stitch counting (1 stitch)
- and a stitch length of 3.5 mm.
● Select the seam section end function (number key 9).
● Select the stitch counter function to open the input menu.
● Enter the number of stitches.
● Confirm the entry with the Enter key.
● Confirm the seam section end by pressing the Enter key.
● Select the stitch length function (number key 4).
● Enter the stitch length.
● Confirm with the Enter key.
● Select the program end function (number key 0).
● Confirm the decorative seam by pressing the Enter key.
11.15.03 Example of Teach In programming
The following seam is to be created:
Enter
Enter
5
3
Enter
Enter
Seam section 3Seam section 1
Seam section 2
The seam to be programmed is:
- to contain 3 seam sections
- and to be saved with the comment „Learn“
- at program number 8.