Sealing
43
10.05.07 Example of how to enter a sealing program
The following example should be filed under program number "10" with the comment
"PROG10", and should consist of three seam zones:
- Seam zone 1 with switch to another zone after 200 mm seam length
- Seam zone 2 with reduced sealing speed and speed difference between the top and bot
tom feed roller, and switch to another zone after 100 mm
- Seam zone 3 with original sealing speed without speed difference between the feed
rollers and with switch to another zone after 400 mm
Switch on the machine.
Call up the programming function.
●
●
Enter program number "10".●
Confirm input.
The sealing parameters from the manual sewing mode are taken over for seam zone 1.
●
To Next Page
Loading...
