Programming
These functions are used to enter the Creating or Altering Heat-Sealing Programs, see
Chapter 10.03 Creating/altering sealing programs.
Input menu
This function is used to call up the "Input" mode, see Chapter 11 Input.
Stop
(This function appears during the heat-sealing operation.)
This function is used to stop the heat-sealing operation, analog to pedal function "-1", also
see Chapter 7.03 Pedal.
10.09 Error messages
In case of a malfunction, an error code appears on the display. An error message may be
caused by incorrect handling, faults on the machine or by overload conditions.
For the explanation of the error code, see Chapter 13.11 Explanation of the error numbers.
Eliminate the error.
Acknowledge the elimination of the error.
10.10 Turning the rollers
Call up manual sealing or dynamic sealing, see Chapter 9.02 Selecting a program.
Call up the function for turning the rollers.
●
●
●
●
To Next Page
Loading...
