Display Description
ERROR: 317 Write error in MDAT-file
ERROR: 318 Machine data identification incorrect
ERROR: 319 Read error in MDAT-file
ERROR: 330
#Prog. No. #Range No.
Program. speed > max. gear-controlled speed
ERROR: 331
#Prog. No. #Range No.
Programmed feed roller pressure is higher than the feed rol-
ler pressure limit
ERROR: 332
#Prog. No. #Range No.
Speed and differential are outside the permissible values
ERROR: 340
#Range No.
Incorrect value amplitude/power switch
ERROR: 341
#Range No.
Incorrect value for power or amplitude
FEHLER: 342
#Range No.
Programmed sealing off not plausible
ERROR: 343
#Range No.
Programmed output (OUT) not plausible
PROGRAMM XX
NICHT IM SPEICHER
Program XX does not exist
ERROR: 401 Text file cannot be opened
ERROR: 402 Error in read text file
ERROR: 501 Error when opening file "pikto.hex" or "vorlagen.hex" discon-
nect error
ERROR: 502 No ACK from control panel
13.11.02 Ultrasonoic generator errors
Error no. Description
0 No error
1 Excess temperature
2 Short circuit
3 Amplitude
4 Overload / wobble
To Next Page
Loading...
