13.09 Protective switch and boot key
The protective switch 1 serves as a protection against major damage in case of
a short circuit or overload. The boot key 2 is used to boot-up the machine cont-
rol unit, see Chapter 13.10.02 Loading/updating the operating program.
Disconnect the mains plug!
Danger from electric voltage!
Before switching the machine on again, first eliminate the cause of the fault!
Eliminate the cause of the fault.
Open the control box and reset protective switch 1.
Close the control box again.
●
●
●
Fig. 13 - 05
1
1
2
To Next Page
Loading...
