Sewing Mode
3 Sewing Mode
Sewing mode is the first view on the graphic display
after you turn on the machine. Your selected stitch will
be shown in real size in the stitch field. Here you will
find all the basic information you need to start sewing.
This is also the menu where you adjust the settings of
your stitch. Straight stitch is selected by default.
Note: It’s not possible to sew with the embroidery unit
attached.
Sewing Mode — Overview
1. Stitch field
2. Selected stitch number
3. Stitch width/stitch positioning
4. Stitch length/density
Note: The tabs on the bottom of the screen indicates which
mode is selected. The selected mode is indicated by the black
tab disappearing on screen.
By pressing one of the direct selection buttons, you
select that stitch number immediately. Press two or
three digits in quick succession to select a stitch from 10
and up. If the stitch number does not exist, you will hear
a beep and the last entered digit will be selected as a
stitch. Use the up and down arrow buttons on the wheel
to step between stitches.
Press the info button to show sewing recommendations
for the current stitch. Press the button again to hide the
information.
1. Needle recommendation/setting
Universal needle
Set for twin needle
Wing needle recommended
Set for stitch width safety
2. Presser foot recommendation
3. Stabilizer recommended
4. Feed dog/IDT™ system recommendation
5. Thread tension value
Note: All symbols and options will not be shown at the same
time.
33
To Next Page
Loading...
Need help?
General
