Maintenance
Bobbin Thread Breaks
Did you insert the bobbin properly? Check the bobbin thread.
Is the needle plate hole damaged? Change the needle plate.
Is the bobbin area clean? Clean lint from bobbin area and use only the bobbins
approved for this model.
Is the bobbin wound correctly? Wind a new bobbin.
The Seam Has Uneven Stitches
Is the thread tension correct? Check needle thread tension and the threading.
Are you using too thick or slubbed thread? Change the thread.
Is the bobbin thread evenly wound? Check bobbin winding.
Is a correct needle used? Insert a proper needle correctly as described in see page
22.
The Machine Does Not Feed or Feeds Irregularly
Did you thread the machine properly? Check how the machine is threaded.
Has sewing lint collected between the feed dogs? Remove the needle plate and clean the feed dogs with a
brush.
Are the feed dogs raised? Raise the feed dogs.
Unable To Sew a Buttonhole
Machine beeps when using the One step buttonhole foot
5 ?
Make sure the accessory tray is attached to the machine
and the buttonhole lever is lowered all the way down.
Lower the presser foot gently.
The Embroidery Design is Distorted
Is the fabric hooped properly? The fabric must be tightly hooped.
Is the inner embroidery hoop completely inserted in the
outer embroidery hoop?
Hoop the fabric in such a way that the inner hoop
always exactly matches the outer hoop.
The Embroidery Design has Puckered
Did you stabilize your fabric sufficiently? Ensure you use the proper stabilizer for your technique
or fabric type.
The Machine Will Not Embroider
Is the embroidery unit attached? Make sure that the embroidery unit is properly attached
into the socket.
Is the wrong hoop attached? Slide on the correct hoop.
61
To Next Page
Loading...
Need help?
General
