Embroidering
Color List
All colors in the loaded design are shown in the order
they will be embroidered. Each listed color shows order,
name and thread type. Use the up and down arrow
buttons to view all of the colors in the list.
Embroidery Stitch-Out
Load a Design
This machine has 15 built-in embroidery designs and 86
designs delivered on the USB embroidery stick. All
designs can be viewed in the creative™ 1.5 embroidery
collection booklet available as a PDF file on the USB
embroidery stick.
Load Built-In Designs
With the embroidery unit connected, enter the number
of desired design using the direct selection buttons. The
design will be loaded into the embroidery field in
embroidery stitch-out.
Load Designs From the USB Embroidery Stick
1. To load a design from the USB embroidery stick,
insert the stick into the USB port on the right side of
the machine with the embroidery unit attached and
press the load button. Your machine can load .vp3
embroidery files.
2. Use the arrow buttons to select a folder and then
press OK to open it. To go back to the previous
folder, select the top line and press OK.
3. Select the design you want to load and press OK to
confirm. It will be loaded into the embroidery field
in embroidery stitch-out.
Note: If you have already loaded a design, the next design you
load will automatically replace the first one.
When saving designs to the USB embroidery stick from
your PC, make sure not to create too many levels of sub
folders as this may create a file path that is too long.
Also make sure to keep the file name short.
Load an Embroidery Font
This machine has 2 built-in fonts, curlz and graphite, in
three different sizes. Select a font from creative™ 1.5
embroidery collection booklet and type in the font
number (curlz: 200, 201, 202 or graphite: 300, 301, 302)
using the keypad. The font will load into the
embroidery text editor.
50
To Next Page
Loading...
Need help?
General
