Embroidery Preparations
stitch count (number of stitches in the design) and the
design size are displayed next to each design. The
suggested thread colors for each color number are
shown.
Download Backup Designs
All creative™ 1.5 designs and other files from the USB
stick are also available on our website for backup. Go to
PFAFF® website at www.pfaff.com, click on Support
and select creative™ 1.5 . When downloading the files
you will be asked to enter a code. Enter number:
8200creative
Connect the Embroidery Unit
There is a covered socket behind the free-arm, see
illustration. The cover will open automatically when
connecting the embroidery unit.
1. Make sure the machine is turned off.
2. Slide the accessory tray off.
3. Slide the embroidery unit onto the free arm of the
machine until it plugs firmly into the socket. If
needed, use the level adjusting feet so that the
machine and embroidery unit are even.
4. Turn on the machine. It will automatically restart
and enter embroidery mode.
5. Clear the embroidery area. A pop-up tells you to
remove the hoop for positioning. Press OK. The
machine will calibrate and the embroidery arm will
move to the ready position.
Make sure not to calibrate the machine with the
embroidery hoop attached as this can damage the
needle, presser foot, hoop and/or the embroidery
unit. Be sure to clear all materials from around the
machine before calibrating so that the embroidery
arm does not bump into anything while calibrating.
1. To store the embroidery unit, move the embroidery
arm to park position by selecting park position in the
hoop options menu or the settings menu.
2. Make sure the machine is turned off.
3. Press and pull the button at the left, underneath the
embroidery unit (A) and slide the unit to the left to
remove it.
4. The cover of the socket closes automatically.
5. Store the embroidery unit in the original packing
material.
To Next Page
Loading...
Need help?
General
