Sewing Mode
Stitch Adjustments
Your machine will automatically select optimal settings
for each stitch. You can make adjustments to every
stitch as desired. Adjusted settings only affect the
selected stitch and will be reset to default when another
stitch is selected. Adjusted settings are not automatically
saved when the machine is turned off.
The values for stitch length and stitch width are shown
to the right of the display. Use the next to the buttons
numbers to make adjustments. When a setting is
changed the numbers will be highlighted. When trying
to exceed minimum or maximum settings for width and
length, a warning sound will be heard.
Stitch Width/Stitch Positioning
1. Stitch width/ stitch
positioning
2. Stitch length/ stitch
density/elongation
3. Thread tension
Increase or decrease the stitch width using + and -
buttons. For straight stitches, use + and - to move the
stitch position left or right. When a straight stitch is
selected, the icon changes to show that stitch positioning
is active instead of stitch width.
Stitch Length/Stitch Density
Increase or decrease the stitch length using + and -
buttons.
For satin stitches, use the + and - buttons to increase or
decrease the stitch density. This is often necessary when
specialty threads are used or when a less dense satin
stitch is desired. The stitch density does not affect the
actual length of the entire stitch. When a satin stitch is
selected, the icon changes to show that stitch density is
active instead of stitch length.
Elongation is used to lengthen satin stitches. The entire
stitch will be longer but the density will remain the
same. Press the alt button to show the elongation setting
instead of density for satin stitches. The icon (3) changes
to show an elongation symbol. Increase or decrease the
elongation of the satin stitch using the + and - buttons. If
elongation is not available for the selected stitch, a
warning sound will be heard when pressing the alt
button and the icon will not change.
34
To Next Page
Loading...
Need help?
General
