When the embroidery unit is attached, a pop-up asks
you to remove the hoop and clear the machine area for
calibrating the embroidery arm. Press OK. The machine
will calibrate and the embroidery arm will move to the
ready position.
Note: It is very important to remove the hoop, otherwise the
hoop or the embroidery unit may be damaged while
calibrating.
Connect an USB Embroidery Stick
In embroidery mode if you press the load button
without having a USB embroidery stick connected, this
pop-up will appear. Connect a USB embroidery stick
and press OK to load a design.
The Data On the USB Embroidery Stick Is Not Readable
This pop-up will appear when your sewing machine
cannot access the information on the USB embroidery
stick. This can be caused when incorrect file formats are
saved to the USB embroidery stick. Other reasons could
be that the USB embroidery stick is damaged or not
compatible with the sewing machine.
Design Includes Elements That Cannot Be Opened
Some designs may consist of several designs or contain
other elements that cannot be opened. Use your
complimentary embroidery intro software to re-save the
design as a combined design.
Remove the Hoop
This pop-up will appear when a function has been
chosen that forces the embroidery unit to move outside
the limits for the attached hoop. In order for the
embroidery arm to move freely, remove the hoop and
then press OK.
56
To Next Page
Loading...
Need help?
General
