Mechanical Instructions
EN 14 BJ2.4U/BJ2.5U LA4.
4.3.12 LED Panel
1. After the AmbiLight diffusor frame has been removed, the
LED Panel is accessible.
2. Remove the T10 mounting screws that hold the panel.
3. Take out the panel.
When defective, replace the whole unit. Reconnect the earth-
cable during re-assembly.
4.3.13 LCD Panel
When the AmbiLight Diffusor frame has been lifted, the LCD
Panel can be removed from the set.
4.4 Set Re-assembly
To re-assemble the whole set, execute all processes in reverse
order.
Notes:
• While re-assembling, make sure that all cables are placed
and connected in their original position. See figure "Cable
dressing".
• Pay special attention not to damage the EMC foams on the
SSB shields. Ensure that EMC foams are mounted
correctly.
To Next Page
Loading...
