What to do if Philips Measuring Instruments show 'BAD SERVER LINK'?
If your Philips Measuring Instruments display 'BAD SERVER LINK', it means that you cannot use this combination of Monitor, Measurement Server and cable. Switch off the monitor and contact your biomedical department.
How to resolve 'BAD SERVER LINK plus Measurement Server Revision not supported' on Philips M3046A?
If your Philips Measuring Instruments display 'BAD SERVER LINK' and the status message 'Measurement Server Revision not supported' in red, it means an M3000A Measurement Server with revision A software is connected to an M3046A Monitor with a software revision of B or later, a combination that does not allow monitoring. Update the software to resolve this issue.
Details on monitor, server, and extension theories and functions.
Patient safety, leakage current, and protection against electric shock.
Timetable for suggested maintenance activities for various components.
Specific maintenance tasks for Monitor, Measurement Server, and Extensions.
Detailed procedures for testing temperature, ECG/Resp, invasive pressure, etc.
Procedures for verifying system enclosure leakage current and protective earth continuity.
Detailed troubleshooting for INOP messages, defective components, and specific problems.
Steps for removing covers, pump, and CO2 scrubber from the extension.
Steps for refitting the CO2 scrubber and pump into the extension.
General| Brand | Philips |
|---|---|
| Model | M3046A |
| Category | Measuring Instruments |
| Language | English |
To Next Page