2-9
21
English
Radio Reception
Note:
– Some RDS station may be transmitting a real
time clock at a minute interval. The accuracy of
the transmitted time depends on the transmitting
RDS station.
NEWS
(only available in RDS radio station)
Once the News PTY (Programme Type) is
detected in a RDS station, it will switch to
TUNER mode automatically.
IMPORTANT!
You can activate NEWS function in Standby,
Demonstration or any source mode except
Tuner and Eco Power Standby mode.
To start NEWS function
1
Press NEWS on the remote control.
➜ "
NEWSNEWS
NEWSNEWS
NEWS" and NEWS logo (
) will
appear on the display.
➜ It will scan the radio stations stored in the
first 5 preset and wait for the News Programme
Type data to be available in any of these RDS
radio stations.
● If no RDS station is detected in the first 5
presets, the system will exit NEWS function.
➜ "
NO RDS NEWSNO RDS NEWS
NO RDS NEWSNO RDS NEWS
NO RDS NEWS" will be displayed and
will disappear from the display.
2
When NEWS transmission is detected, the
system will switch to Tuner mode automatically.
➜
will start flashing.
● At the end of news bulletin, the syetem will
switch to the last selected source and resume its
last operation (for example, before detecting the
transmission, the system is playing track 5 of disc
1, it will resume playback from the same
position).
Notes:
–You have to exit Tuner mode before selecting
NEWS function.
– While searching NEWS in progress, the current
source activity will remain uninterrupted.
– Before you activate the NEWS feature, ensure
that the first 5 presets have RDS stations.
– The NEWS works only once for each activation.
– The NEWS will not start if a recording is in
progress.
To cancel NEWS function
● Press NEWS again or press TUNER to select
tuner mode.
● During news bulletin, press any other available
source keys to execute the relevant source
mode.
22
English
Ta pe Operation/Recording
IMPORTANT!
– Before playing a tape, check and tighten
slack tape with a pencil. Slack tape may get
jammed or may burst in the mechanism.
– C-120 tape is extremely thin and is easily
deformed or damaged. It is not
recommended for use in this system.
– Store the tapes at room temperature and
do not put them too close to a magnetic
field (for example, a transformer, TV or
speaker).
Ta pe Playback
1
Press TAPE to select tape mode.
2
Press # OPEN to open the tape deck door.
3
Insert a recorded tape and close the tape door.
● Load the tape with the open side down and the
full spool to the left.
4
Press PLAYÉ(ÉÅ) to start playback.
➜ "
TAPETAPE
TAPETAPE
TAPE" with playback direction indicator will
appear on the display.
To stop playback
● Press Ç.
To change the playback side
● Press í or ë.
➜ The A (BACK) or B (FRONT) appear on
the display, depending on the tape side selected.
To change the playback mode
● Press AUTO REV. on the remote control
repeatedly to select the different playback
modes.
å : playback on one side of the tape only.
∂ : both sides are played once.
∫ : both sides are played repeatedly, up
to 10 times each side unless you pressÇ.
To rewind or fast forward during
playback
● Press and hold à or á until the desired
passage is reached, then release.
➜ The tape continues playing.
● The tape will stop automatically at the end of
the rewinding or fast forwarding.
➜ During searching, the sound is reduced to a
low volume.
To rewind or fast forward when playback
is stopped
1
Press à or á.
2
Press Ç when you reached the desired passage.
-
-+
-
OPEN
STANDBY
-
ON
ECO
POWER
iR
VOL
AUX/ CDR
PROG
PRESET
TAPE
SEARCH/ TUNE
TUNER
DEMO STOPPAUSE
PREV NEXT
REC
STOP
3 CDC
PLAY
BASS TREBLE
NEWS
-+
www.freeservicemanuals.info
To Next Page
Loading...
